They did, though they were stuck in the dark! The new action figure dollhouse isn’t quite finished yet, but it is through no fault of mine. Boy howdy, are dollhouse lights a pain in the ass. I was so thrilled about my decision to go with battery-operated miniature LEDS and external battery adapters, as detailed in this post. LEDs last forever, stay cool, and use so little power!
But I never considered that some battery powered dollhouse LED lights might not FIT the external adapters!
That’s right, some take smaller batteries, and some just have incompatible housings. So it turned out that some lights I ordered, and waited forever for the arrival of, were incompatible. And then I had to order more external housings, not because I needed more battery boxes – I think four is fine for the 20-odd lights – but because I need the adapter plates. Which don’t seem to be available anywhere, at least not yet.
This is why you NEVER USE A TRANSITIONAL TECHNOLOGY FOR A PERMANENT INSTALLATION!
Another problem is that the adapter plates are reliant on a minuscule thread of live wire and a tiny dot of solder to make their connection, and can easily (especially in the process of ceiling installation) be twisted so the connection is broken. I got mad and took one apart, and I haven’t been able to get it to work again. I am fairly good at things like this – I used to rewire antique lamps I bought at Berkeley Flea Market – so I am really peeved. So peeved I’m gonna get a new soldering iron (I gave my old one to beloved friend-muse-Patron Monique Motil) and started reinforcing all the adapters I install from here on.
Which is…four of twenty-odd. Because the others are installed, and the carpet laid over them, and the door frames over that, and then the moldings. This system, which is the time-honored method of giving dollhouses a clean finish, means that the floor covers up your messy wires, the door frame goes in next so you know how much to cut the moldings on either side of it, and the moldings provide a clean edge where floor meets wall and cover any imperfections in floor-cutting. I made a diagram, above! It’s a great system, except when you’re dealing with wiring, because if something goes wrong with the wiring, you have to tear everything out.
I am not pleased, now that I have seen that fragile dab of solder my electricity hinges on.
I did this whole thing to avoid the fragility and propensity to failure of tape-wire dollhouse lighting, which is what the old house has. When I built the old house I learned to solder and soldered all the tapewire connections, because tapewire is notorious for failure when you use the system of brads it comes with. Anyway, tapewire is being deprecated in the States, where it’s much more commonly used than the round wire you see in the UK and Europe. Because of the LED lights coming in.
But nobody has designed a system for someone who wants to wire a whole house with battery LEDS and operate it from one switch.
YET. Never use a transitional technology for a permanent installation. Sigh. As you can see, the house is now mostly lit, but most of the light fixtures are cheap round placeholder lights. It seems I can only really get the compatible lights from Canada. And, the mail is so much worse than usual.
I normally order most of my dollhouse stuff from the UK, because we don’t have to pay duties (until March 29, and then who knows what the hell happens, Theresa May sure has no fucking idea). But ordering stuff from the UK four Sundays before Brexit, while DHL is even more fucked up than usual…well. It certainly does mean a lot of days stuck in mail jail, which is what we call it in Berlin when they say they’re bringing your package and you don’t dare leave the house cause if they leave it with a neighbor or a paketshop you’ll have no idea which one.
Lucky for me, folks visiting from the US are kind enough to bring me things 🙂 Among the things brought by friend & Patron Dan Shick after the holidays are the roof shingles, which I’ve been putting on. You can see them below, I love how they look!